The conditions for starting a slurry pump are as follows:
(1) Perform a standard pre-startup inspection of the slurry pump.
(2) Verify that the slurry pump piping is clear, the designated thickening tank is selected, the water inlet valve is open, the selected thickener is in operation, the thickener's slag discharge and flushing valves are closed, and the slag discharge pump is set to interlock mode.
(3) Ensure the slag pit is free of debris and the water level is above 1.2 meters.
(4) Confirm that the agitator associated with the slurry pump has been started and is operating normally.
(5) Adjust the slurry pump's variable-frequency drive (VFD) to a setting below 10%.
(6) Start the slurry pump via the Distributed Control System (DCS); once the outlet valve is fully open, gradually adjust the VFD frequency to meet the water volume requirements of the reclaimed water tank.
(7) After the slurry pump has started successfully, monitor the coordination between the slurry pump discharge and the reclaimed water pump discharge, as well as the water temperature in the slag extractor.
Startup Conditions for Slurry Pumps
Popular Products
-
Horizontal Centrifugal Slurry Pump Anti-Wear High Chrome Alloy Impeller Back ...Wear is the real cost driver in most slurry systems. When quartz-rich ore, crushed rock fines or heavy tailings pass...read more
-
Wear Resistant Horizontal Slurry PumpIntroduction: Operating Environments and Mechanics of Abrasive Wear in Slurry Systems Handling aggressive,...read more
-
Horizontal Centrifugal Slurry Pump A05 High Chrome AlloyA Wear-Resistant Slurry Pump Built for Demanding Industrial Duties The Horizontal Centrifugal Slurry Pump A05 High...read more
-
Heavy Duty Horizontal Centrifugal Slurry PumpModern Slurry Transport Dynamics and Centrifugal Pumping Architecture Hydraulic pipeline transport of solids-laden...read more
Send Inquiry
