Maintenance of Slurry Pumps

Oct 05, 2026

Leave a message

When maintaining a slurry pump, the following points should be observed:
(1) Ensure that the water pressure and flow rate for the bearings meet the specified requirements. Regularly adjust (or replace) the packing to ensure proper tightness, preventing any slurry leakage at the shaft seal. Replace the shaft sleeve in a timely manner.
(2) When replacing bearings, ensure that the bearing assembly is free of dust and that the lubricating oil is clean. During pump operation, the bearing temperature should generally not exceed 60–65°C, with a maximum limit of 75°C.
(3) Ensure the motor and pump are properly aligned (coaxial). Verify that the elastic elements (cushions) in the coupling are intact and correctly positioned; replace them promptly if damaged.
(4) Ensure that all pump components and the piping system are installed correctly, securely, and reliably.
(5) Certain components of a slurry pump are classified as wear parts. Monitor their wear during daily operation and perform repairs or replacements as needed. During the repair or replacement of these parts, ensure correct assembly and proper clearance adjustments to prevent binding or excessive friction.
(6) The suction piping system must be completely airtight. During operation, also check the suction inlet for any blockages. Since the medium handled by a slurry pump often contains solid particles, the screen (grille) placed in the feed tank must be sized according to the maximum particle size the pump can handle; this helps prevent large particles or long fibrous materials from entering the pump casing and causing blockages.

Send Inquiry